10. If you are connecting a second HMC to your managed server, connect to the Ethernet port that is
labeled LINK HMC2 on the managed server.
11. If you use an external modem, plug the modem power supply cord into the HMC modem.
12. Plug the power cords for the monitor, HMC, and HMC external modem into electrical outlets. If you
are connecting this HMC to a new managed system, do not connect the managed system to a power
source at this time.
Next, you will need to configure your HMC software. Continue with “Configuring the HMC” on page
49.
Related concepts:
“Deciding which connectivity method to use for the call-home server” on page 5
Learn more about the connectivity options you have when you use the call-home server.
“HMC network connections” on page 3
Installing the 7310-CR4 HMC into a rack
This section describes how to install the 7310-CR4 HMC into a rack. This is a customer task.
If an HMC is used to manage any POWER7 processor-based system, the HMC must be a CR3, or later,
model rack-mounted HMC.
The following is a rear-view of the 7310–CR4:
24 Power Systems: Installing and configuring the Hardware Management Console
To Next Page
Loading...
Need help?
General
