IBM L150 - OPERATING INSTRUCTIONS; GENERAL INSTRUCTIONS; CONTROL BUTTONS

IBM 15” Service Manual
7
3. OPERATING INSTRUCTIONS
3.1 GENERAL INSTRUCTIONS
Press the power button to turn the monitor on or off. The other control buttons are located
at front panel of the monitor. By changing these settings, the picture can be adjusted to
your personal preferences.
-
The power cord should be connected.
-
Connect the video cable from the monitor to the video card.
-
Press the power button to turn on the monitor, the power indicator will light up.
3.2 CONTROL BUTTONS
-
Power Button:
When pressed, the monitor enters the off mode, and the LED turns blank. Press again to
restore normal status.
- Left / Right Button:
The Left/Right Button is used to control the monitor functions. Press to switch functions
or adjust settings.
- Auto Adjust Key:
The Auto Adjust Key is used to automatically set the H Position, V Position, Clock and Phase.
- Power Indicator:
Green — Power On mode.
orange — Power Saving mode.
Blank —Power Off Mode.
LED = GREEN, BLINKING (0.5s period) —Out of Range
A. Exit
B. Left button / Auto button
C. Right button/Brightness Menu button
D. Menu button
E. Power button
F. Indicator light
3.3 ADJUSTING THE PICTURE
Control Buttons
http://www.wjel.net