18. Using your labels, replace the PCIe risers and adapters. For instructions, see “Replacing a PCIe
adapter in the 7063-CR1 system” on page 25.
19. Replace the eight fan power connectors into the system backplane. For instructions, see “Replacing a
system fan in the 7063-CR1” on page 17.
20. Using your labels, replace the memory DIMMs. For instructions, see “Removing and replacing
memory in the 7063-CR1” on page 20.
21. Install the system processor air baffle as shown in Figure 44 on page 43. Insert the edge of the
system processor air baffle into the fan support. Then, carefully press the system processor air baffle
down into place.
Figure 43. Processor socket screws on bottom of chassis
42 Power Systems: Servicing the 7063-CR1 Hardware Management Console system
To Next Page
Loading...
