IBM Power Systems 7063-CR1 User Manual

6. Place the system into the service position. For instructions, see “Placing a 7063-CR1 system into the
service position” on page 77.
CAUTION:
Do not place any object on top of a rack-mounted device unless that rack-mounted device is
intended for use as a shelf. (R008)
(L012)
or
CAUTION: Pinch hazard. (L012)
7. Remove the service access cover. For instructions, see “Removing the service access cover from a
7063-CR1 system” on page 75.
Preparing the 7063-CR1 system for operation after you remove and
replace internal parts
Learn how to prepare the IBM 7063-CR1 Hardware Management Console system for operation after you
remove and replace internal parts.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Replace the service access cover. For instructions, see “Installing the service access cover on a
7063-CR1 system” on page 76.
3. Place the system into the operating position. For instructions, see “Placing a 7063-CR1 system into the
operating position” on page 78.
(L012)
or
CAUTION: Pinch hazard. (L012)
4. Reconnect the power cords to the system. For instructions, see “Connecting the power cords to a
7063-CR1 system” on page 80.
5. Start the system. For instructions, see “Starting the 7063-CR1 system” on page 69.
6. Verify the installed part. For instructions, see Verifying a repair (www.ibm.com/support/
knowledgecenter/POWER9/p9ej5/p9ej5_verifyrepair.htm).
68 Power Systems: Servicing the 7063-CR1 Hardware Management Console system

IBM Power Systems 7063-CR1 Specifications

General

Model	7063-CR1
Type	Server
Operating System	AIX, IBM i, Linux
RAID Levels	0, 1, 5, 6, 10
Memory Slots	16
Storage	SAS
Processor Cores	4 per processor
Disk Bays	8
Power Supply	Redundant
Form Factor	Rack-mountable