IBM Power Systems 7063-CR1 - System Preparation for Servicing

10. Press the top of the pen to release the system processor module onto the cover.
Replacing a system processor module in the 7063-CR1
Learn how to replace a system processor module in the IBM 7063-CR1 Hardware Management Console
system.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Inspect the system processor socket area and remove any dust or debris (use a can of compressed air).
Figure 51. Placing the system processor module at an angle on the top cover of the packaging
Figure 52. Releasing the pen
50 Power Systems: Servicing the 7063-CR1 Hardware Management Console system