To Next Page

To Previous Page

Replacing the USB cable and connector in the 7063-CR1

Learn how to replace the USB cable and connector in the IBM 7063-CR1 Hardware Management Console

systems.

Procedure

1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged

into a ground jack or connected to an unpainted metal surface. If not, do so now.

2. Route the USB and serial cables in through the front of the system, then slide the USB cable and

connector into of the front of the system as shown in Figure 62 on page 59, until it clicks into place.

The serial cable is non-functional, and may not be included in your system.

Figure 61. Removing the USB cable and connector

58 Power Systems: Servicing the 7063-CR1 Hardware Management Console system

Questions and Answers:

Need help?

Do you have a question about the IBM Power Systems 7063-CR1 and is the answer not in the manual?

IBM Power Systems 7063-CR1 Specifications

General