2-2 ServeRAID Controller Hardware Installation
2.2 Quick Installation
The following steps are for quick installation of your controller. These
steps are for experienced computer users/installers. Section 2.3,
“Detailed Installation,” contains the steps for all others to follow.
Step 1. Review all safety information provided with the server; then,
turn off the power to the server and all of the attached devices,
and unplug the server and the device power cords.
Step 2. Open the cabinet of the host system by following the
instructions in the host system technical documentation.
Step 3. Install the controller in the server and connect the SAS devices
or the SATA II devices to it. Make sure that the cables you use
conform to all specifications.
Step 4. Perform a safety check.
a. Make sure that all cables are properly attached
b. Make sure that the controller is installed correctly
c. Close the cabinet of the host system
Step 5. Reconnect the power cords to the system and to all attached
devices.
Step 6. Turn on the power to the system after you complete the safety
check.
2.3 Detailed Installation
This section provides detailed instructions for installing a ServeRAID
M5014 controller or a ServeRAID M5015 controller.
Step 1. Unpack the Controller
Unpack and remove the controller. Inspect it for damage. If it
appears damaged, or if any of the following items are missing,
contact your place of purchase. The controller is shipped with
the following items:
– A CD containing an electronic version of this
User’s Guide and other related documentation
To Next Page
Loading...
Need help?
General
