IBM Storwize V5030 Quick Installation Guide

Remove the bottom (1U) fascia
3. Gently pull on each side of the PSU fascia to remove it from the chassis, as
shown in Figure 74. The PSU fascia disengages from the slot and pin that
connect it to each side of the chassis.
You must remove the bottom fascia to access and service either PSU. However,
as Figure 75 on page 88 shows, you do not have to remove the front fascia.
svc01043
Figure 74. Remove fascia components from the expansion enclosure
Chapter 2. Installing the system hardware 87

IBM Storwize V5030 Specifications

General

Model	IBM Storwize V5030
Category	Storage
Controller Enclosures	1 or 2
Maximum Drives	240
RAID Levels	0, 1, 5, 6, 10
Virtualization	Yes
Data Compression	Yes
Maximum Hosts	512
Form Factor	2U
Drive Types	SAS, NL-SAS, SSD
Host Interface	8 Gb FC, 16 Gb FC, 10 Gb iSCSI, 12 Gb SAS
Processor Cores	8 per controller