3. Plug the replacement cable into the specific port.
4. Ensure that the SAS cable is fully inserted. A click is heard when the cable is
successfully inserted.
Replacing a control enclosure chassis
This topic describes how to replace a control enclosure chassis.
Before you begin
Note: Ensure that you know the type of enclosure chassis that you are replacing.
The procedures for replacing a control enclosure chassis are different from those
procedures for replacing an expansion enclosure chassis. For information about
replacing an expansion enclosure chassis, see “Replacing an expansion enclosure
chassis” on page 113.
svc00651
Figure 38. SAS cable
108 Storwize V7000: Troubleshooting, Recovery, and Maintenance Guide
To Next Page
Loading...
