Description
This command resets the service assistant password to the default value passw0rd.
If the node canister is active in a system, the superuser password for the system is
reset; otherwise, the superuser password is reset on the node canister.
If the node canister becomes active in a system, the superuser password is reset to
that of the system. You can configure the system to disable resetting the superuser
password. If you disable that function, this action fails.
This command calls the satask resetpassword command.
Snap command
Use this command to collect diagnostic information from the node canister and to
write the output to a USB flash drive.
Syntax
satask snap -options
Parameters
-options
(Optional) Specifies which diagnostic information to collect.
Description
This command moves a snap file to a USB flash drive.
This command calls the satask snap command.
Apply software command
Use this command to install a specific upgrade package on the node canister.
Syntax
satask installsoftware -file filename
-ignore
Parameters
-file
(Required) The file name of upgrade package .
-ignore
(Optional) Overrides prerequisite checking and forces installation of the
upgrade package.
Description
This command copies the file from the USB flash drive to the upgrade directory on
the node canister and then installs the upgrade package.
This command calls the satask installsoftware command.
40 Storwize V7000: Troubleshooting, Recovery, and Maintenance Guide
To Next Page
Loading...
Need help?
General
