3. Push the front-panel assembly toward the chassis until it clicks into place.
4. Reroute and connect the front-panel assembly cable to the system board (see
“System-board internal connectors” on page 17 for the location of the
front-panel connector).
5. Install the air duct.
6. Install the side cover (see “Installing the side cover” on page 167).
7. Stand the server back up in its vertical position.
8. Install bezel (see “Installing the bezel” on page 171).
9. Reconnect the external cables and power cords; then, turn on the attached
devices and turn on the server.
To install the front-panel assembly on the 5U server model with hot-swap power
supplies (Model name: 2582-F4x), complete the following steps. For 4U server
models with non-hot-swap power supplies, please see the above sub-section.
1. Carefully turn the server on its side so that it is lying flat.
Attention: Do not allow the server to fall over.
2. Position the front end of the front-panel assembly in the channel above bay 1.
3. Push the front-panel assembly toward the front of the chassis until it clicks into
place.
Chapter 5. Removing and replacing server components 229
To Next Page
Loading...
