IBM System x3100 M4

Table 6. IMM2 error messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v If an action step is preceded by “(Trained technician only),” that step must be performed only by a trained
technician.
806f010f-2201xxxx The System %1
encountered a POST
Hang.
(%1 =
CIM_ComputerSystem.
ElementName)
Error The System
encountered a
firmware hang.
(Sensor =
Firmware Error)
1. Make sure the server meets the
minimum configuration to start.
2. Update the server firmware on the
primary page.
Important: Some cluster solutions
require specific code levels or
coordinated code updates. If the
device is part of a cluster solution,
verify that the latest level of code
is supported for the cluster solution
before you update the code.
3. (Trained technician only) Replace
the system board.
806f052b-2101xxxx IMM2 FW Failover has
been detected.
Error Invalid or
unsupported
firmware or
software was
detected.
1. Make sure the server meets the
minimum configuration to start.
2. Recover the server firmware from
the backup page:
a. Restart the server.
b. At the prompt, press F3 to
recover the firmware.
3. Update the server firmware to the
latest level (see “Updating the
firmware” on page 267).
Important: Some cluster solutions
require specific code levels or
coordinated code updates. If the
device is part of a cluster solution,
verify that the latest level of code
is supported for the cluster solution
before you update the code.
4. Remove components one at a
time, restarting the server each
time, to see if the problem goes
away.
5. If the problem remains, (trained
technician only) replace the
system board.
General messages
806f0023-2101xxxx Watchdog Timer
expired for IPMI
Watchdog.
Info A watchdog timer
expired has been
detected.
No action; information only.
806f0123-2101xxxx Reboot of system
initiated by IPMI
Watchdog.
Info A reboot by a
watchdog occurred
has been
detected.
No action; information only.
806f0223-2101xxxx Powering off system
initiated by IPMI
Watchdog.
Info A poweroff by
watchdog has
been detected.
No action; information only.
Chapter 3. Diagnostics 59