1. Read the safety information that begins on page vii and “Installation guidelines”
on page 95
2. Align the system board with the chassis and replace the six screws that you
removed.
3. Replace the microprocessor and microprocessor heat sink (see “Installing a
microprocessor” on page 138).
4. Reconnect to the system board the cables that you disconnected in step 6 of
“Removing the system board” on page 144.
5. Replace the RAID controller, if present (see “Installing the RAID controller” on
page 117).
6. Replace the DIMMs (see “Installing a memory module” on page 110).
7. Replace the riser-card assemblies and adapters, if any were installed.
8. Replace the four jack screws connected to the video connector and the serial
connector at the rear of the server.
9. Install the cover (see “Installing the cover” on page 98).
10. Slide the server into the rack.
11. Reconnect the power cords and any cables that were removed.
12. Turn on the peripheral devices and the server.
Important:
Perform the following updates:
146 IBM System x3550 Type 7978 and 1913: Problem Determination and Service Guide
To Next Page
Loading...
