IBM TX PRO-II - Advanced Chipset Setup Page

Chapter 3
Advanced Chipset Setup Page
This page sets some of the timing parameters for your system.
Before making changes to this page, you must ensure that your
hardware supports the new values.
DRAM Auto
Configuration
When this item is set to Enabled, the BIOS will
automatically configure some of the DRAM
timing items below. If it is set to Disabled, you
must insert the DRAM timing values manually.
SDRAM Access
Time
This item determines the access time for
installed SDRAM.
EDO Dram Access
Time
This item determines the access time for
installed EDO RAM.
FP Dram Access
Time
This item determines the access time for
installed Fast Page mode DRAM.
Refresh Cycle
Time
This item determines the cycle time for
refreshing the memory chips.
OnChip USB
Use this item to enable or disable the onboard
USB ports.
USB Function for
DOS
Use this item to enable or disable the onbaord
USB ports in the DOS environment.
32