8. Align the USB flash device with the connector on the system board and push it
into the connector until it is firmly seated.
9. Slide the lockbar toward the riser-card assembly to the locked position until it is
seated firmly.
If you have other devices to install or remove, do so now. Otherwise, go to
“Completing the installation” on page 89.
Note: You must configure the server to boot from the hypervisor USB drive. See
Chapter 3, “Configuring the server,” on page 95 for information about enabling the
embedded hypervisor.
88 System x3630 M4 Type 7158: Installation and User’s Guide
To Next Page
Loading...
