Completing the installation
To complete the installation, complete the following steps:
1. If you removed the air baffle, install it (see “Installing the air baffle” on page 90).
2. If you removed the PCI riser-card assemblies, replace the riser-card assemblies
(see “Installing the PCI riser-card assembly” on page 90).
3. If you have the optional hot-swap rear hard disk drive cage installed, rotate it
down (see “Rotating the optional hot-swap rear hard disk drive cage down” on
page 93).
4. If you removed the server top cover, replace it (see “Installing the server top
cover” on page 93).
5. Install the server in a rack. See the Rack Installation Instructions that come with
the server for complete rack installation and removal instructions.
6. To attach peripheral devices and connect the power cords, see “Front view” on
page 12.
Note: Remember to route the power cord through the cable retainer clip so that
it does not accidentally become disconnected.
Chapter 2. Installing optional devices 89
To Next Page
Loading...
