Installing the air baffle
To replace the air baffle, complete the following steps:
1. Align the tabs on the air baffle with the slots on the chassis.
2. Lower the air baffle into the server. Make sure that the tabs on the air baffle are
inserted into the holes on the chassis.
Attention: For proper cooling and airflow, replace the air baffle before you
turn on the server. Operating the server with the air baffle removed might
damage server components.
If you have other devices to install, do so now. Otherwise, go to “Completing the
installation” on page 89.
Installing the PCI riser-card assembly
To install the PCI riser-card assembly, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 35.
2. Make sure that the server and all peripheral devices are turned off and that the
power cords and all external cables are disconnected.
3. Reinstall any adapters and reconnect any internal cables that you removed in
other procedures.
4. Align the PCI riser-card assembly with the alignment pin and the guide rails on
the chassis.
For 2U riser card assemblies:
90 System x3630 M4 Type 7158: Installation and User’s Guide
To Next Page
Loading...
