v For 1U PCI riser-card assembly 2:
Note: For 1U PCI riser-card assembly 2, it only supports ServeRAID
adapters (see “Removing a ServeRAID adapter from the PCI riser-card
assembly”).
8. Place the adapter on a flat, static-protective surface.
9. If you are instructed to return the adapter, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Removing a ServeRAID adapter from the PCI riser-card assembly
To remove a ServeRAID adapter from the PCI riser-card assembly, complete the
following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 35.
2. Turn off the server and peripheral devices and disconnect all power cords and
external cables.
3. Remove the server top cover (see “Removing the server top cover” on page
44).
4. If you have the optional hot-swap rear hard disk drive cage installed, rotate it up
(see “Rotating the optional hot-swap rear hard disk drive cage up” on page 46).
5. Remove PCI riser-card assembly 2 (see “Removing the PCI riser-card
assembly” on page 46).
6. Pull the release pin to unlock the retention latch; then rotate the retention latch
to the open position.
7. Carefully grasp the ServeRAID adapter by the edge and pull it out of PCI
riser-card assembly 2.
For 2U riser card:
Chapter 2. Installing optional devices 53
To Next Page
Loading...
