Installing a USB hypervisor memory key
Hypervisor is a virtualization platform that enables multiple operating systems to run
on a host computer at the same time. Support for hypervisor is available with the
purchase and installation of an optional USB hypervisor memory key, with
embedded hypervisor software.
To install the USB hypervisor memory key, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 35.
2. Turn off the server and peripheral devices and disconnect all power cords and
external cables (see “Turning off the server” on page 24).
3. Remove the server top cover (see “Removing the server top cover” on page
44).
4. If you have the optional hot-swap rear hard disk drive cage installed, rotate it up
(see “Rotating the optional hot-swap rear hard disk drive cage up” on page 46).
5. Remove PCI riser-card assembly 1 (see “Removing the PCI riser-card
assembly” on page 46).
6. Locate the USB hypervisor connector on the USB connector board in the server.
7. Slide the lockbar on the flash device connector to the unlocked position.
Chapter 2. Installing optional devices 87
To Next Page
Loading...
