Table 10. Server configuration and applications for configuring and managing RAID arrays
Server configuration
RAID array configuration
(before operating system is
installed)
RAID array management
(after operating system is
installed)
ServeRAID-H1110 adapter LSI Utility (Setup utility, press
Ctrl+C), ServerGuide, Human
Interface Infrastructure (HII)
MegaRAID Storage Manager
(MSM), SAS2IRCU
(Command Line) Utility for
Storage Management
ServeRAID-M1115 adapter MegaRAID BIOS
Configuration Utility (press
Ctrl+H to start), pre-boot CLI
(press Ctrl+P to start),
ServerGuide, HII
MegaRAID Storage Manager
(MSM), MegaCLI (Command
Line Interface), and IBM
Director
ServeRAID-M5110 adapter;
ServeRAID-M5120 adapter
MegaRAID BIOS
Configuration Utility (press
Ctrl+H to start), pre-boot CLI
(press Ctrl+P to start),
ServerGuide, HII
MegaRAID Storage Manager
(MSM), MegaCLI, and IBM
Director
ServeRAID-C105 HII MegaRAID Storage Manager
(MSM), MegaCLI, and IBM
Director
Notes:
1. For more information about Problem Determination and Service Guide for
ServeRAID M controllers, see http://www-947.ibm.com/support/entry/portal/
docdisplay?lndocid=MIGR-5085607.
2. For more information about Configuration and Options Guide (COG), see
http://www-947.ibm.com/support/entry/portal/docdisplay?lndocid=SCOD-
3ZVQ5W&brandind=5000019.
3. For further details on creating a software RAID array of hard disk drives, please
see the ServeRAID C105 documentation at http://www-947.ibm.com/support/
entry/portal/docdisplay?lndocid=MIGR-5089068
4. When the ServeRAID adapter is removed, software RAID will not be supported.
This system does not support downgrade software RAID function from hardware
RAID configuration.
Starting the LSI Configuration Utility program
Use these instructions to start the LSI Configuration Utility program.
To start the LSI Configuration Utility program, complete the following steps:
1. Turn on the server, and make sure that the server is the owner of the keyboard,
video, and mouse.
2. When the prompt message is displayed, you may perform either of the
following:
a. ServeRAID H1110: press CTRL+C.
b. ServeRAID M5110, ServeRAID M5120,orServeRAID M1115: press
CTRL+H.
When you have finished changing settings, press Esc to exit from the program;
select Save to save the settings that you have changed.
Chapter 3. Configuring the server 111
To Next Page
Loading...
