Installing the hot-swap backplane on the optional rear hard disk drive
cage
To install the hot-swap backplane for the optional rear hard disk drive cage,
complete the following steps.
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 35.
2. Turn off the server and peripheral devices and disconnect all power cords and
external cables (see “Turning off the server” on page 24).
3. Remove the server top cover (see “Removing the server top cover” on page
44).
4. Connect the LED signal, SATA signal and power cables to the backplane.
5. Align the backplane with the slot on the optional rear hard disk drive cage.
6. Lower the backplane into the optional rear hard disk drive cage. Make sure the
three alignment pins securely engages the three holes on the hard disk drive
cage.
7. For information on how to connect the relevant cabling on the backplane to the
server, please refer to “Installing an optional hot-swap rear hard disk drive cage”
on page 56.
Note: Make sure that Port 1 is connected to Port 1 for both backplanes.
Likewise, Port 0 is connected to Port 0 for both backplanes.
Chapter 2. Installing optional devices 69
To Next Page
Loading...
