Table 1. Features and specifications
Microprocessor:
v Supports multi-core Intel Xeon
microprocessors, with integrated
memory controller and Quick Path
Interconnect (QPI) architecture
v Designed for LGA 1356 socket
v Scalable up to eight cores
v 32 KB instruction cache, 32 KB data
cache, and up to 20 MB L3 cache that
is shared among the cores
v Support for Intel Extended Memory
32/64 Technology (EM32/64T)
Note:
v Use the Setup utility to determine the
type and speed of the microprocessors.
v For a list of supported microprocessors,
see http://www.ibm.com/systems/info/
x86servers/serverproven/compat/us/.
Memory (depending on the model):
v Slots: 12 dual inline memory module
connectors on the base system board
(six per microprocessor).
v Minimum: 2 GB
v Maximum: 384 GB
v Type: 1066 MHz, 1333 MHz or 1600
MHz, ECC, single-rank or dual-rank
– UDIMM: 2 GB or 4 GB
– RDIMM: 2 GB, 4 GB, 8 GB, 16 GB,
or 32 GB (when available)
v Chipkill supported
Drive Expansion bays (depending on
the model):
v Twelve 3.5-inch SAS/SATA hot-swap
hard disk drive bays with option to add
two more rear 3.5-inch SAS/SATA
hot-swap hard disk drive bays
v Eight 3.5-inch SAS/SATA hot-swap hard
disk drive bays
v Eight simple-swap 3.5-inch SATA hard
disk drive
v Four simple-swap 3.5-inch SATA hard
disk drive.
Note: For specific models that may be
shipped initially with four hard disk
drives, configuration may be able to
expand to eight hard disk drives via
Features on Demand (FoD).
PCI expansion slots:
Supports eight different PCI adapters and
up to five PCI expansion slots depending
on server model.
v Riser 1 (1U PCI riser-card assembly)
– One full-height half-length PCIe3.0
Express x16 slot, x16 link speed
– One full-height half-length PCIe3.0
Express x8 slot, x8 link speed and
one low-profile PCIe3.0 Express x8
slot, x8 link speed
PCI expansion slots (continued):
v Riser 1 (2U PCI riser-card assembly):
– One full-height full-length PCIe3.0
Express x16 slot, x16 link speed
– One full-height full-length PCIe3.0
Express x16 slot, x8 link speed and
one full-height half-length PCIe3.0
Express x16 slot, x8 link speed
v Riser 2 (1U PCI riser-card assembly):
– One low-profile PCIe3.0 Express x8
slot, x4 link speed
– One low-profile PCIe3.0 Express x8
slot, x8 link speed (
Note: Second CPU must be
attached to system board when
using this slot)
v Riser 2 (2U PCI riser-card assembly):
– One low-profile PCIe3.0 Express
x16 slot, x16 link speed (
Note: Second CPU must be
attached to system board when
using this slot)and one low-profile
PCIe3.0 Express x8 slot, x4 link
speed
– Two low-profile PCIe3.0 Express
x16 slot, x8 link speed (
Note: Second CPU must be
attached to system board when
using these slots) and one
low-profile PCIe3.0 Express x8 slot,
x4 link speed
Integrated functions:
v Integrated Management Module II
(IMM2), which provides service
processor control and monitoring
functions, video controller, and remote
keyboard, video, mouse, and remote
hard disk drive capabilities
v Onboard Intel Powerville 4-port Gigabit
Ethernet controller with Wake on Lan
support (by default Ethernet 1 and 2
are enabled, to enable Ethernet 3 and
4, it is done through the Features on
Demand (FoD))
v Onboard PCH with LSI software RAID
with support for RAID levels 0, 1 and
10
v Light path diagnostics
v Eight Universal Serial Bus (USB) ports
(two on front, four on rear of server,
and two internal for an optional USB
hypervisor flash device)
v One serial port
v One video port on rear of server
Note: Maximum video resolution is
1600 x 1200 at 75 Hz.
v One front video port based on model.
Note: In messages and documentation,
the term service processor refers to the
integrated management module II (IMM2).
Integrated Video controller:
v Matrox G200eR2 video on system board
v Compatible with SVGA and VGA
v DDR2-250MHz SDRAM video memory
controller
v Video memory 16MB is not expandable
v No DVI connector
v Avocent digital video compression
v Maximum video resolution is 1600 x 1200
at 60 or 75 Hz
ServeRAID controllers:
v ServeRAID M1115 SAS/SATA Controller
for IBM System x
v ServeRAID M5110 SAS/SATA Controller
for IBM System x
v ServeRAID M5120 SAS/SATA Controller
for IBM System x
v ServeRAID H1110 SAS/SATA Controller
for IBM System x
v ServeRAID M5100 Series Battery Kit for
IBM System X
v ServeRAID C105 for IBM System X
ServeRAID controller upgrade:
v ServeRAID M5100 Series 512MB
Cache/RAID 5 Upgrade for IBM System x
v ServeRAID M5100 Series 512MB
Flash/RAID 5 Upgrade for IBM System x
v ServeRAID M1100 Series Zero
Cache/RAID 5 Upgrade for IBM System x
v ServeRAID M5100 Series Zero
Cache/RAID 5 Upgrade for IBM System x
v ServeRAID M5100 Series RAID 6
Upgrade for IBM System x
v ServeRAID M5100 Series 1GB
Flash/RAID Upgrade for IBM System x
Environment:
v Air temperature:
– Server on: 5°C to 40°C (41°F to
104°F); altitude: 0 to 915 m (3000 ft).
– Server on: 5°C to 32°C (41°F to
89.6°F); altitude: 915 m (3000 ft) to
2134 m (7000 ft).
– Server on: 5°C to 28°C (41°F to
82.4°F); altitude: 2134 m (7000 ft) to
3050 m (10000 ft).
– Server off: 5°C to 45°C (41°F to 113°F)
– Shipping: -40°C to 60°C (-40°F to
140°F)
v Humidity:
– Server on: 8% to 85%; maximum dew
point: 24°C; maximum rate of change:
5 °C/hr
– Server off: 8% to 80%; maximum dew
point: 27°C
– Shipment: 5% to 100%
6 System x3630 M4 Type 7158: Installation and User’s Guide
To Next Page
Loading...
