5. Place the focus on Move and press the left or right navigation button to
finely drive the dish east or west for the best signal. The dish rotates con-
tinuously as long as either of these buttons is held down.
6. Choose Store Satellite Position from Positioner Command to save the dish’s
current position for the target satellite.
It may be useful to set limits to the movement scope of the dish for easier ma-
nipulation. Repeat these steps two times to set a limit position for the east and
the west.
1. Choose Go to Reference from Positioner Command for the dish to return
to the reference point.
2. Place the focus on Move and press the left or right navigation button to drive
the dish.
3. Choose Set East (soft) Limit or Set West (soft) Limit from Positioner Com-
mand to save the dish’s current position to use it as a limit position.
Choosing Disable (soft) Limits from Positioner Command clears these limit po-
sitions.
Using USALS
Open the apps screen and select Settings > Positioner Setting. Set Positioner
to USALS and then specify these items correctly:
• Dish Longitude: Enter the longitude where the dish is located.
• Dish Latitude: Enter the latitude where the dish is located.
Give the dish a test run to see if it works properly. Repeat these steps for every
desired satellite.
1. Choose Go to Reference from Positioner Command for the dish to return
to the reference point.
2. Choose Satellite and choose a target satellite.
3. Choose Frequency and select any available transponder.
4. Choose Go to to rotate the dish so that it faces the target satellite.
S C 25
To Next Page
Loading...
