4
. Remove the top panels to gain access to
t
he water reservoir.
5
. Remove the float reservoir cover an d with a
piece of copper wire short the two metal pins of
the water level sensor.
6. Place a water pan under the freezer water
i
nlet port, disconnect the water hose from this
port and allow the water from the freezer to flow
i
nto the pan.
Then refit the water hose to the freezer water
inlet port.
7. Prepare the cleaning solution by diluting in
a plastic container two or three liters of warm
water (45
-50 C) with a 200/300 liter s
of Citric Acid (on SF1000 double the quantities).
8. Pour the cleaning solution into the water
reservoir.
9. After 15 minutes switch ON the Master
switch to start the unit.
10. Wait till the machine starts to discharge ice,
then continue toslowly p o ur the cleaning solution
into the water reservoir taking care to maintain
the level just below the overflow.
11. When all the cleaning solution has been
used up, open the water shutoff valve to allow
new fresh water to flow into the reservoir. Let the
u
nit to continue to run until the ice resumes the
normal colour and hardness.
12. Stop the icemaker and pour warm water on
the ice deposited into the storage bin to melt it up.
N
OTE. DO NOT use ice produced with the
Citric Acid solution. Be sure none remains
i
n the bin.
13. Pour into the water reservoir 1 cc. (approx
20 drops) of Icematic Sanitiser (Antialgae P/N
CF 264000.00) then switch the unit ON.
14. Left the unit running for approx 1 0 minutes
then remove the copper wire used to jump the
two sensors for the water level and place back
correctly the cover on the float reservoir.
NOTE. DO NOT use ice produced with the
sanitising solution.
15. With a sponge moisted with a sanitising
solution, wipe clean all the bin interior surfaces.
REMEMBER. To prevent the accumulation
of undesirable bacteria it is necessary to
sanitise the interior o f the storage bin with an
anti-algae disinfectant solution every week.
To Previous Page
Loading...
