IceTech IceBlast KG20 User Manual

MANUAL FOR KG20 KG6 KG6 BASIC
DRY ICE BLASTING EQUIPMENT FROM ICETECH | PAGE 19
“ Examine the hose for cracks
and other damage before starting
the machine ”
MAINTENANCE
Daily Before Starting the Machine
1 Examine the hose for cracks and other damage.
Examine the whole length of the hose to see
whether there are areas which are softer than
others, and which indicate that the inner hose is
worn or fractured.
2 Pay special attention to points where the hose
may have become kinked during operation.
3 If any kind of damage is noted, it must be dealt
with by an IceTech technician who will have the
appropriate tools and equipment to ensure that
repaired equipment complies with safety
regulations.
4 Examine electrical plugs for damage and replace
them if necessary.
5 Check to ensure that the batteries are fully charged.
After 100 Hours´ Operation
1 Examine connections for wear and tear or other
damage. Tighten up or replace them as necessary.
2 Check the dispensing system for damage and leaks.
3 Pour a small amount of Dry Ice pellets into the
funnel and activate the blasting gun trigger switch.
If back-pressure air at the bottom of the funnel is
noted, an IceTech technician must be contacted
to adjust the dispensing system.
After 500 Hours´ Operation
1 Replace the dispensing disc.
2 Replace the upper and lower wear insert at the
dispensing disc.
3 Check, adjust and tighten the dispensing system.
4 Test the hose.
5 Replace the diaphragm in the pilot-controlled
pressure regulator.
(After 500 hours of operation, all mainte-
nance must be carried out by an IceTech
technician).

IceTech IceBlast KG20 Specifications

General

Brand	IceTech
Model	IceBlast KG20
Category	Shot Blasting Machines
Language	English