Procedures for maintenance and repair
www.icetechworld.com | IceTech Dry Ice Technology | Rev 1
Page 16
Procedure no. 4 Replacement of hydraulic oil filter
Procedure step by step
1. Dismount the 4 screws pos. 1 from the return oil filter housing pos. 4.
2. Remove the housing top plate pos. 2.
3. Take out the return oil filter cartridge and replace it with a new one. Be careful not to
make any damage while replacing it into the housing.
4. Assemble again by placing the housing top plate pos. 2 on top of the return oil filter
housing pos. 4.
5. Mount the 4 screws pos. 1 again tightening evenly and firmly.
BEFORE STARTING PRODUCTION THE HYDRAULIC STATION SHOULD BE CHECKED
IN SINGLE MODE!
Operating in single mode control
Check that there are no leaks on the hydraulic station.
The operation is complete.
1Selectsinglemode
2EnterManualoperation
3Startthehyd.pump
4Movethepistonsusing
thearrowbuttons
To Next Page
Loading...