Procedures for maintenance and repair
www.icetechworld.com | IceTech Dry Ice Technology | Rev 1
Page 23
Procedure no. 6 Replacement of wear inserts in die changer.
BEFORE STARTING PRODUCTION THE HYDRAULIC MOTION SHOULD
BE CHECKED IN SINGLE MODE!
Operating in single mode control
It is important to check that both extruder cylinder and die changer cylinder is operating
correctly, before production start up.
The operation is complete.
1Selectsinglemode
2EnterManualoperation
3Startthehyd.pump
4Movethepistonsusing
thearrowbuttons
To Next Page
Loading...