Procedures for maintenance and repair
www.icetechworld.com | IceTech Dry Ice Technology | Rev 1
Page 32
Procedure no. 7 Replacement of Ø160 hydraulic cylinder.
BEFORE STARTING PRODUCTION THE HYDRAULIC MOTION SHOULD
BE CHECKED IN SINGLE MODE!
Operating in single mode control
The operation is complete.
At production startup, it’s important to check if the degassing sleeves are tightened correctly.
1Selectsinglemode
2EnterManualoperation
3Startthehyd.pump 4Movethepistonsusing
thearrowbuttons
To Next Page
Loading...