14
2
PANEL DESCRIPTION
■ Function controller screen
q RECEIVE MODE BUTTONS [AM], [FM], [WFM] (p. 18)
Select a receive mode.
w AUTOMATIC RECEIVE MODE BUTTON [AUT-M] (p. 19)
Selects an automatic receive mode. This mode selects a
previously programmed receive mode automatically de-
pending on the receive frequency.
e TONE SQUELCH BUTTON [TSQL] (p. 36)
Push to show or hide the [TONE SQUELCH] dialog box for
setting tone squelch frequencies.
r SQUELCH UP/DOWN BUTTONS [SQLJ]/[SQLK]
(p. 20)
Adjust the squelch threshold level. The squelch removes
noise output from the speaker (closed condition) when no
signal is received.
t IF FILTER BUTTONS [NAR]/[WID] (p. 20)
Push to change the IF filter in use. The [WID] button se-
lects a wider filter, the [NAR] button selects a narrower fil-
ter.
•Usable IF filters vary according to receive mode.
y ATTENUATOR BUTTON [ATT] (p. 21)
Push to turn the 20 dB attenuator on and off.
u AUTOMATIC NOISE LIMITER BUTTON [ANL] (p. 21)
Push to turn the automatic noise limiter for receiving AM
signals on and off.
i FREQUENCY UP/DOWN BUTTONS
[FREQJ]/[FREQK] (p. 17)
Push to set the receive frequency with the selected tuning
step.
o TUNING STEP UP/DOWN BUTTONS [TSJ]/[TSK]
(p. 18)
Push to select the tuning steps.
To Next Page
Loading...
