30
5
SCAN OPERATION
■ Memory scan
This function searches all memory channels in a selected
memory bank.
D Using the multi-function receiver screen
q Make sure the squelch is set to the threshold point. (closed
condition)
w Click the [BANK
∧] or [BANK∨] button to select the de-
sired memory bank.
•When using the memory list screen, click [BANK#]/[BANK$]
or select a bank name with [$] to select a memory bank.
e Click the [SET] button to call up the setting screen if it is
not displayed.
r Click the [Memory SCAN] tab.
t Make sure the check boxes are not checked (%) then click
the close (["]) button.
y Click the [MEMO] button to start memory scan.
•“MEMO”flashes while scanning.
u To cancel the scan, click [STOP] or [MEMO].
D Using the multi-function receiver screen
q Make sure the squelch is set to the threshold point. (closed
condition)
w Click the [BANK] button and select the desired memory
bank.
•When using the memory list screen, click [BANK#]/[BANK$]
or select a bank name with [$] to select a memory bank.
e Call up the setting screen if it is not displayed.
•Click the [MENU] button and select the ‘Function Setting (SET).’
•When the scan controller screen is in use, click the [SET] button
on the screen.
r Click the [Memory SCAN] tab.
t Make sure the check boxes are not checked (%) then click
the close (["]) button.
y Click the [MEMO] button in the scan controller screen to
start memory scan.
•“Memory SCAN”flashes while scanning.
u To cancel the scan, click [STOP] or [MEMO].
To Next Page
Loading...
