Set the radio to communicate at 147.480 MHz simplex
0. Turn on the radio and make sure it’s unlocked
(press and hold SET to unlock)
1. Press the right MAIN to select the right
transceiver
2. If the right display is in Memory mode, press
the right V/MHz to enter VFO mode
3. Press the right V/MHz to select tens of MHz,
then turn the right big knob so that the right
display reads 14
4. Press the right V/MHz to select MHz, then turn
the right big knob so that the right display
reads 147
5. Press the right V/MHz to select kHz, then turn
the right big knob so that the right display
reads 147.480
6. Select the desired power level by pressing
LOW repeatedly
7. Press and hold the right M/CALL until you
hear a single beep
8. Turn the right big knob until the right display
reads 25
9. Press and hold the right M/CALL to save the
frequency and settings
Now stored in radio memory channel 25
To Previous Page
Loading...
