Icom ic-2730A Programming Manual

©June 2016 Icom America Inc. Page 2
Icom America, Inc.
12421 Willows Road NE
Kirkland, WA 98034
Saving these settings to Memory
Your display should show your frequency, the duplex (DUP+ or DUP-), and the T for tone encoder. To
save these settings to a Memory Channel, do the following:
1. Press the [MW] key.
2. MW will blink on the display.
3. Rotate your dial to display CH SEL (channel selection).
4. Press the Enter key.
5. Rotate the dial to the memory channel you wish to use.
6. Press the Enter key.
7. Rotate the dial to WRITE.
8. Press the Enter key.
9. The display will show WRITE.
10. Rotate the dial to YES.
11. Press the Enter key.
Verify the Programming
To check the memory channels, momentarily press the [MR/CALL] key and rotate the dial through the
memory channels and confirm that the repeater is programmed into the memory channel that you
selected.

Icom ic-2730A Specifications

General

Frequency Range	144-148 MHz, 430-450 MHz
Mode	FM
Power Output	50W, 15W, 5W
Antenna Connector	SO-239
Power Supply Requirement	13.8V DC ±15%
Voltage	13.8V DC
Operating Temperature	-10°C to +60°C
Number of Channels	1000
Current Consumption	13A (at 50W output)