4 BASIC OPERATION
. Selecting the operating channel
Push [UP]/[A] or [DOWN]/["'] keys sev-
eral times until the desired operating
channel number appears on the dis-
play.
.While pushing and holding [UP]/[A] or
[DOWN]/["'] keys, the displayed chan-
nel changes continuously until chan-
nel number" 1 " appears.
If you want to keep the automatic se-
lection, release the [UP]/[A] or
[DOWN]/["'] keys then push and hold them again.
.When displayed channel stops at channel number "01", a warn-
ing beep is emitted.
c,-c,=c,"
~ NOTE:
~.The transceiver has 14 operating frequency channels.
~ .The selected channel is memorized when you turn off the
~ transceiver.
9
---
-- - - --
5111
RECEIVEAND TRANSMIT
CD Push and hold [MODE] 1sec.
to open the squelch. Busy indicatorTT ~
.Adjust volume to the desired appears.~ 0----.
audiolevel.(Seep. 8) f/~ e]
0 Select a desired operating channel. l!!U
When a signal is received: ~ .....
.Squelch opens and audio is emitted :1J:tr ce/D
fromthe speaker. ~,.
.Further adjustment of [VOL] may be c,-c,=c",
necessary at this point.
. "BUSY" indicator appears on the dis-
play.
W Push and hold [PH] to transmit" then
speak into the microphone.
.Do not hold the transceiver too close
to your mouth or speak too loudly.
This may distort the signal.
.The transmit indicator"" "appears
on the display.
@)Release [PTT] to return to receive.
c,-c,=c",
~ IMPORTANT:
~ To maximize the readability of your transmitted signal, pause a
~few sec. after pushing[PTT],holdthe transceiver2 to 4 inches
~(5 to 10 cm) from your mouth and speak at a normal voice level.
~NOTE:
~The transceiverhas an auto power save functionto conserve
~ the battery power. The power save function activates automati-
'l} cally when no signal is received for 5 sec.
10
---
To Next Page
Loading...
