8 OTHER FUNCTIONS
. ATS (Automatic Transponder System)
This allows you to confirm whether or not a call has reached the re-
ceiving party even if the operator is temporarily away from the
transceiver. No "Ring" tone is emitted with this function.
.. Push [MODE], while [PTT] is
ON to turn the function
ON/OFF.
. "iii..,"appearsonthedisplay. ..
.The transceiver starts to send a
searching signal every 60 sec.
- When the transceiver receives an
answer back signal, "iii " stays on
the display until the next search
transmit.
- Ifno reply is received, "iii " blinksuntilthe nextsearch transmit.
- A caution beep is emitted when the condition changes.
0_0_00
~NOTE: Above setting is for the calling station only. A called party
~ automatically sends an answer back signal without any preset-
~tings.
~ AIIIC-4008A's operating on the same operating channel will an-
~ swer back to your call in your communication area.
. Low battery indicator
.. Appears when the battery is nearing
exhaustion.
.A warning beep is emitted at power
ON.
.. Appears and blinks when battery re-
placement is necessary.
--- -
OTHERFUNCTIONS 8
. LCD backlight
.. Automatically turns ON for 5 sec. when you push any key, ex-
cept [PTT].
.Auto power save
.. The power save function reduces the current drain to conserve
battery power.
- The function automatically turns ON when no operation is per-
formed or no signal is received for 5 sec.
. Resetting the transceiver
Initialize the operating conditions before
using the transceiver for the first time, or if
the function display shows erroneous in-
formation.
.. While pushing [DOWN]/["'] and
[MODE], push [POWER] ON to initial-
ize the transceiver.
~CAUTION: Resetting the transceiver returns all settings to their
~ defaults.
To Next Page
Loading...
