3. Assemble the screen cover and handle by inserting the M5 x 45mm button head screws from the
handle into the screen cover. Don’t push the screws all the way in yet. If you have difficulty
getting the screws to go through the holes, try twisting them in.
4. Now place the handle and cover assembly inside the brackets you mounted on the frame in step
2. Line up the holes in the bracket with the M5 screws, and push the screws all the way through
so they protrude through the brackets on both sides. This is easiest to do if you hold the cover
flat against the front of the rig.
To Next Page
Loading...
