What to do if destination station’s call sign (UR) has not been registered to the gateway server on my Icom IC-705?
If the destination station’s call sign (UR) has not been registered to the gateway server, or the call sign does not match your Icom Transceiver’s setting, check the destination station’s register information.
What to do if the Terminal/AP call sign that is set in the Icom IC-705 Transceiver has not been registered in the RS-RP3C as the access point?
If the Terminal/AP call sign that is set in the Icom Transceiver has not been registered in the RS-RP3C as the access point, register the Terminal/AP call sign that is set in the transceiver in the RS-RP3C as the access point.
What to do if the call sign has not been added to 'Allowed Call Sign List' in the Icom IC-705?
If the call sign has not been added to 'Allowed Call Sign List' in the Icom Transceiver, when 'Allowed Call Sign' is set to 'Enable': * Set 'Allowed Call Sign' to 'Disable' in the INTERNAL GATEWAY SETTINGS screen. * Add the Remote D-STAR transceiver’s call sign to 'Allowed Call Sign List' in the INTERNAL GATEWAY SETTINGS screen.
What to do if Gateway Repeater cannot be found on Icom Transceiver?
If the Gateway Repeater cannot be found on your Icom Transceiver, check the WLAN settings.
General| Bluetooth | Yes |
|---|---|
| WLAN | Yes |
| SD Card Slot | Yes |
| Antenna Connector | BNC |
| Frequency Range | 0.030–199.999 MHz |
| Modes | SSB, CW, AM, FM |
| Receiver Type | Superheterodyne |
| GPS | Built-in |
| Battery | Lithium-ion |
| Weight | Approx. 1.1 kg |
| Type | Portable |
| Power Supply | 13.8 V DC |
| Waterproof Standard | IP54 |
| Operating Temperature Range | -10°C to +60°C |
| Display | 4.3 inch color TFT touch screen LCD |
To Next Page
