Icom IC-706MKIIG

4 - 11
SET MODE ADJUSTMENT (continued)
ENTERING
ADJUSTMENT
SET MODE
SENSITIVITY
S-METER
• Enter adjustment set mode:
1 Turn power OFF.
2 Terminate the [REMOTE] jack with a
3.5(d) mm mini-plug.
3 While pushing [P.AMP/ATT] and
[TUNE/CALL], turn power ON.
• Connect a standard signal generator to
[ANT2] and set as:
Frequency : 60.05150 MHz
Modulation : OFF
• Receiving
• Connect an SSG to [ANT1] connector and
set as:
Frequency : 14.1515 MHz
Level : OFF
• Receiving
• Set an SSG as :
Level : 50 μV (–73 dBm)
Modulation : OFF
• Receiving
• Set an SSG as :
Level : 50 mV (–13 dBm)
Modulation : OFF
• Receiving
VHF1 BPF1 L
S0 LEVEL
S9 LEVEL
+60dB LEVEL
Push [F-2 (RX)] to enter the RX
adjustment setting mode.
Then advance to the following set-
ting, or push [UP]/[DN] to scroll the
display.
Set a connected SSG’s level at 10
dB of S/N ratio with AC millivolt-
meter.
Set maximum AF level using the
[MAIN DIAL], then push [MENU] to
set the "VHF1 BPF1 L".
Push [MENU] to set the "S0 level".
Push [MENU] to set the "S9 level".
Push [MENU] to set the "+60 dB
level".
• The display returns to the same as
the ADUSTMENT SET MODE above.
Push [F-1 (EXIT)] to exit adjustment set mode.
ADJUSTMENT ADJUSTMENT CONDITION DISPLAY OPERATION
1
1
2
3
1
2
3
USB
RX TX
• Same operation as step 2 for the listed BPFs.
• Set an SSG as:
Modulation : OFF
VHF1 BPF2 L : 60.05150 MHz
VHF1 BPF1 M : 90.50150 MHz VHF1 BPF2 M : Same as left
VHF1 BPF1 H : 128.9515 MHz VHF1 BPF2 H : Same as left
VHF2 BPF1 L : 129.1015 MHz VHF2 BPF2 L : Same as left
VHF2 BPF1 M : 145.1515 MHz VHF2 BPF2 M : Same as left
VHF2 BPF1 H : 170.0015 MHz VHF2 BPF2 H : Same as left
UHF BPF1 L : 400.0015 MHz UHF BPF2 L : Same as left
UHF BPF1 M : 435.1515 MHz UHF BPF2 M : Same as left
UHF BPF1 H : 470.0015 MHz UHF BPF2 H : Same as left
• Receiving