What to do if no sound comes from the Icom Transceiver speaker?
If no sound is coming from the speaker of your Icom Transceiver, ensure that the volume level isn't too low by pressing the [?] or [?] buttons to adjust it to a suitable level. Also, check if an external speaker is connected or a cloning cable is inserted, and disconnect them if they are.
How to fix an Icom Transceiver that will not power ON?
If your Icom Transceiver won't power ON, you should first replace the batteries or charge the battery pack. Check for loose connections of the battery pack (case) and clean the battery terminals. Also, verify that the battery polarity is correct.
Why is transmitting impossible on my Icom Transceiver?
If transmitting is impossible with your Icom Transceiver, first, replace the exhausted batteries or charge the battery pack. Then, ensure that the frequency is set within the 144/440 MHz amateur bands; if it is outside, reset it.
What to do if Icom Transceiver memory scan function cannot start?
If the memory scan function on your Icom Transceiver cannot start and the displayed frequency is erroneous, push [M/CALL] to set memory mode if VFO mode or call channel is selected. Ensure that you have programmed 2 or more memory channels. If the issue persists, try resetting the transceiver, or removing and re-attaching the battery pack or battery case.
Why is no contact possible with another station on my Icom Transceiver?
If no contact is possible with another station using your Icom Transceiver, check the tone/DTCS using tone scan because a different tone may be selected with tone/DTCS squelch.
General| Frequency Range | 144-148 MHz, 430-450 MHz |
|---|---|
| Channels | 1000 |
| Display Type | LCD |
| Output Power | 5W |
| Modulation | FM |
| RF Power Output | 5 W |
| Weight | 300g (With BP-256) |
| Battery Life | 10 hours |
| Operating Voltage | 7.4 V |
| Voltage | 7.4 V |
| Dimensions | 58(W) x 105(H) x 26.4(D) mm (w/o projections) |
To Next Page
