Icom IC-80AD - REPEATER AND DUPLEX OPERATIONS

FLAT
CABLE
LOGIC unit
A
B
B
B
B
Front panel
E
D
B
B
B
A
C
Rear panel
A
A
A
D
D
B
B
B
RF UNIT
Rear panel
C
RF UNIT
Rear panel
MAIN UNIT
3 - 1
1. Removing the rear panel
q Unscrew 2 screws A and remove the plate B.
w Unscrew 2 screws C and 2 screws D.
e Disconnect the flat cable E from MAIN UNIT.
r Remove the rear panel.
3. Removing the RF UNIT
q Unsolder 2 points A.
w Unsolder 3 points B and remove the shield plate C.
e Unscrew 4 screws D and remove the RF UNIT from the
rear panel.
2. Removing the MAIN UNIT
q Unsolder 5 points A.
w Unscrew 3 screws B.
e Remove the MAIN UNIT from the rear panel.
4. Removing the LOGIC UNIT
1 Unsolder 2 points A.
2 Unscrew 6 screws B and remove the LOGIC UNIT
from the front panel.
SECTION 3
.
DISASSEMBLY INSTRUCTION
BE CAREFUL about the fl at cable and connector when
separating the CHASSIS UNIT from the FRONT UNIT.
All manuals and user guides at all-guides.com