D Command formats
• Operating frequency
Command: 00, 03, 05, 1C 03
XX X X X
X
XX XX
~ 9
~ 9
~ 9
~ 9
~ 9
~ 9
~ 9
~ 9
~ 1
~ 4
• Operating mode
Command: 01, 04, 06
q w
XX X X
q
Operating mode
w
Filter setting
00:LSB 05 :FM 01:FIL1
01:USB 07 :CW-R 02:FIL2
02:AM 08 :RTTY-R 03:FIL3
03:CW 17 :DV —
04:RTTY 22 :DD* —
* 22 Command (DD) can be selected when setting the
1200 MHz band to other than the satellite mode.
L Filter setting, (
w
) can be skipped with command 01
and 06. In that case, “FIL1” is selected with command
01 and the default lter setting of the operating mode is
automatically selected with command 06.
• Duplex Offset frequency setting
Command: 0C, 0D
X X X
X
XX
~ 9
~ 9
~ 9
~ 9
~ 9
~ 9
LOnly the 1200 MHz band can input 10 MHz digits.
• Band edge frequency settings
Command: 02*, 1E 01, 1E 03
X X X
X X X X X X X X X 2 D X X X X X X X X X X
10 Hz digit: 0 ~ 9
1 Hz digit: 0
~ 9
1 kHz digit: 0
~ 9
100 Hz digit: 0
~ 9
100 kHz digit: 0
~ 9
10 kHz digit: 0
~ 9
10 MHz digit: 0
~ 9
1 MHz digit: 0
~ 9
1 GHz digit: 0
~ 1
100 MHz digit: 0
~ 4
10 Hz digit: 0 ~ 9
1 Hz digit: 0 ~ 9
1 kHz digit: 0 ~ 9
100 Hz digit: 0 ~ 9
100 kHz digit: 0 ~ 9
10 kHz digit: 0 ~ 9
10 MHz digit: 0 ~ 9
1 MHz digit: 0 ~ 9
1 GHz digit: 0 ~ 1
Separator (fixed)
Edge number*: 01 ~ 30
* When obtaining the edge number (by command “02”),
the edge number (q) is not returned.
• Codes for CW message contents
Command: 17 Up to 30 characters
To send CW messages, use the following character
codes.
Character ASCII code
0 ~ 9 30 ~ 39
A ~ Z 41 ~ 5A
a ~ z 61 ~ 7A
/ 2F
? 3F
. 2E
− 2D
, 2C
: 3A
Character ASCII code
’ 27
( 28
) 29
= 3D
+ 2B
” 22
@ 40
Space 20
L“FF” stops sending CW messages.
L “^” is used to transmit a string of characters with no
inter-character space.
Remote control
13
To Next Page
Loading...
