What to do if Icom Transceiver shows DDError icon?
If your Icom Transceiver displays a DDError icon, it could be due to a couple of reasons. First, the connection between the transceiver and the router might be incorrect; in this case, check the connection between the transceiver and the router. Second, the Gateway Repeater may not be found; if so, check the NETWORK settings.
General| Receiver Type | Triple conversion superheterodyne |
|---|---|
| Display | 4.3 inch color TFT touch screen |
| Type | VHF/UHF/1.2GHz All Mode Transceiver |
| Receiver System | Triple conversion superheterodyne |
| D-STAR | Yes |
| Antenna Impedance | 50 ohms |
| Power Supply | 13.8V DC ±15% |
| Frequency Range | 144-146 MHz, 430-440 MHz, 1240-1300 MHz |
| Mode | FM, SSB, CW, AM |
| Antenna Connector | 2m/70cm: SO-239, 23cm: Type-N |
| Dimensions | 240 x 94 x 238 mm |
| Weight | Approx. 4.7 kg |
| RF Power Output | 2m/70cm: 100W, 23cm: 10W |
| GPS | Yes (Internal) |
| Sensitivity | 0.18 μV (FM) |
To Next Page
