4
RECEIVING AND TRANSMITTING
4-10
Split Lock function
To prevent accidentally changing the receive
frequency by releasing
while rotating
,
use the Split Lock function. Using both this function
and the Dial Lock function enables you to change only
the transmit frequency.
1. Turn ON the Split Lock function.
» SET > Function > SPLIT > SPLIT LOCK
2. Turn ON the Split function.
3. Hold down
for 1 second to turn ON the Dial
Lock function.
4. While holding down
, set the transmit
frequency.
Setting the transmit lter width
SSB mode
The transmit lter width for the SSB and SSB-D
modes can be set. Only for the SSB mode, WIDE
(wide), MID (middle) or NAR (narrow) can be selected.
To change the lter width in the SSB mode:
1. Set the operating mode to USB or LSB.
2. Push
.
• Opens the FUNCTION screen.
3. Touch [TBW ].
L Touching [TBW] sets the lter width to WIDE, MID or
NAR.
The transmit lter widths are set to the following
values by default.
• SSB (WIDE): 100 Hz to 2900 Hz
• SSB (MID): 300 Hz to 2700 Hz
• SSB (NAR): 500 Hz to 2500 Hz
• SSB-D: 300 Hz to 2700 Hz
L You can change the lter width values in the following
settings.
»
SET > Tone Control/TBW > TX > SSB > TBW (WIDE)
»
SET > Tone Control/TBW > TX > SSB > TBW (MID)
»
SET > Tone Control/TBW > TX > SSB > TBW (NAR)
»
SET > Tone Control/TBW > TX > SSB-D > TBW
Operating CW
D Setting the CW pitch control
You can set the received CW audio pitch and the CW
side tone to suit your preference without changing the
operating frequency.
1. Select the CW mode.
2. Display the Multi-function menu.
3. Touch [CW PITCH].
4. Set the CW pitch to between 300 and 900 Hz (in
5 Hz steps).
5. Push
to close the Multi-function menu.
Push
D Setting the key speed
You can set the keying speed of the internal electric keyer.
1. Select the CW mode.
2. Display the Multi-function menu.
3. Touch [KEY SPEED].
Push
4. Set the key speed to between 6 and 48 Words Per
Minute (WPM).
5. Push
to close the Multi-function menu.
To Next Page
Loading...
