Icom IC-9700 - Tone Control;Tbw

8
SET MODE
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
8-2
Tone Control/TBW
MENU
» SET > Tone Control/TBW > RX
SSB, AM, FM, DV, CW, RTTY
RX HPF/LPF (Default: – – – – – – – – –)
Sets the cut-off frequencies for the receive audio high-
pass lter and low-pass lter, in 100 Hz steps.
L If this item is set, the “RX Bass” and “RX Treble” items are
automatically set to “0.”
SSB, AM, FM, DV
RX Bass (Default: 0)
RX Treble (Default: 0)
Sets the bass or treble level of the receive audio.
MENU
» SET > Tone Control/TBW > TX
SSB, AM, FM, DV
TX Bass (Default: 0)
TX Treble (Default: 0)
Sets the bass or treble level of the transmit audio.
SSB
TBW (WIDE) (Default: 100 – 2900)
TBW (MID) (Default: 300 – 2700)
TBW (NAR) (Default: 500 – 2500)
Sets the transmission passband width to wide, mid,
or narrow, by changing the lower and higher cut-off
frequencies.
SSB-D
TBW (Default: 300 – 2700)
Sets the transmission passband width by changing
the lower and upper cut-off frequencies.
Function
MENU
» SET > Function
Beep Level (Default: 50%)
Sets the beep output level.
L If the “Beep (Conrmation)” item is set to “OFF,” no beeps
sound.
Beep Level Limit (Default: ON)
Selects whether or not to limit the volume up to the
specied level.
• OFF: Does not limit the volume level.
• ON: Limits the volume level.
Beep (Conrmation) (Default: ON)
Turns the Conrmation beep ON or OFF.
• OFF: Turns the function OFF for silent operation.
• ON: A beep sounds when a switch is pushed or
the touch panel is touched.
L If the “Beep Level” item is set to “0%,” no beep sounds.
Band Edge Beep (Default: ON (Default))
Selects an option for the Band Edge Beep function.
• OFF: Turns OFF the function.
• ON (Default): A beep sounds when you tune outside
of, or back into the default amateur
band’s frequency range.
• ON (User): A beep sounds when you tune outside
of, or back into a user programmed
amateur band’s frequency range.
• ON (User) & TX Limit:
A beep sounds when you tune outside
of, or back into a user programmed
amateur band’s frequency range.
Transmitting is inhibited outside of the
range.
L If the “Beep Level” item is set to “0%,” no beep sounds .
Beep Sound (MAIN) (Default: 1000Hz)
Beep Sound (SUB) (Default: 1000Hz)
Sets the audio frequency for beeps.
L If the “Beep Level” item is set to “0%,” no beep sounds.
MENU
» SET > Function > Sub Band Mute (TX)
Speaker/Phones (Default: OFF)
USB (Default: OFF)
LAN (Default: OFF)
Selects whether or not to mute the received audio of
the SUB band when you transmit.
• OFF: Does not mute the received audio of the SUB
band.
• ON: Mutes the received audio of the SUB band.