Icom IC-9700 - Registration Process

3
BASIC OPERATION
3-5
Setting the frequency (Continued)
D About the 1/4 Tuning function
Mode: SSB-D/CW/RTTY
With the Tuning Function OFF, turn ON the 1⁄4 Tuning
function to reduce the tuning speed to 1⁄4 of the
normal speed, for ner tuning.
1. Push
FUNCTION
.
• Opens the FUNCTION screen.
2. Touch [1/4].
1/4 Tuning
function
3. Push
EXIT
.
D Directly entering a frequency
You can set the frequency without rotating
MAIN DIAL
by directly entering it on the keypad.
Entering the operating frequency
1. Touch the MHz digits. (Example: 146)
• Opens the F-INP screen.
3. Start entry with the most significant digit.
• Opens the BAND STACKING REGISTER screen.
2. Touch [F-INP].
LTo clear the entry, touch [CE].
L To clear the entry and return to the previous screen,
push
EXIT
.
4. Touch [ENT] to set the entered frequency.
• Closes the F-INP screen.
L If you touch [ENT] when the digits under 100 kHz are
not entered, “0” will be automatically entered into the
digits that are blank.
Entry examples
• 144.680 MHz: [1], [4], [4], [•(−)], [6], [8], [0], [ENT]
• 145.000 MHz: [1], [4], [5], [ENT]
• Changing from 144.680 MHz to 144.540 MHz:
[•(− )], [5], [4], [0], [ENT]
FUNCTION screen
D About the Auto Tuning Step function
The tuning step automatically changes, depending on
the rotating speed of
MAIN DIAL
.
L You can change the Auto Tuning Step function settings in
the following menu. (p. 8-4)
MENU
» SET > Function > MAIN DIAL Auto TS