Icom IC-9700 - Monitor Function

4
RECEIVING AND TRANSMITTING
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
4-7
Rotate
Push
Monitor function
The Monitor function enables you to monitor your
transmit audio. Use this function to check the
voice characteristics while adjusting transmit audio
parameters.
L You can hear the CW sidetone regardless of the Monitor
function setting.
1. Select the operating mode that you want to
monitor. (Example: USB)
2. Push
FUNCTION
.
• Opens the FUNCTION screen.
3. Touch [MONI] to turn ON the Monitor function.
LTouching [MONI] turns the Monitor function ON or OFF.
4. If you want to adjust the monitor audio output,
touch [MONI] for 1 second.
5. Rotate
MULTI
to adjust MONITOR to the clearest
audio output between 0% and 100%, while
speaking at your normal voice level.
NOTE: When using the VOX function, turn OFF the
Monitor function. Otherwise the transmitted audio will
echo.
6. To close the NOTCH menu, push
EXIT
.
IP Plus function
The IP Plus function improves the Intermodulation
Distortion (IMD) quality by exerting the direct sampling
system performance.
This function optimizes the Analog/Digital Converter
(ADC) against the distortion when you receive a
strong input signal. It also improves the Third-order
Intercept Point (IP3) while minimizing the reduction of
the receive sensitivity.
1. Push
FUNCTION
.
• The FUNCTION screen is displayed.
2. Touch [IP+].
LTouch [IP+] to turn the IP Plus function ON or OFF.
L Select ON to prioritize the IP quality, and select OFF
to prioritize the receive sensitivity.
3. To close the FUNCTION screen, push
EXIT
.