Icom IC-9700 - Page 16

D Command formats (Continued)
• Band stacking register
Command: 1A 01
q
XXXX
w
NOTE:
When sending the contents, the codes, such as operating
frequency and operating mode*, should be added after
the frequency band code and the register code, as shown
below.
* See t to %1 on ‘Memory content setting.’ (p. 14)
q Frequency band codes
Code Freq. band Frequency range (unit: MHz)
01 VHF 144.000000 ~ 148.000000
02 UHF 430.000000 ~ 450.000000
03 1.2GHz 1240.000000 ~ 1300.000000
w Register codes
Code Registered number
01 1 (Display on left side)
02 2 (Display in center)
03 3 (Display on Right side)
To read the contents, the register code should be
added after the frequency band code, as shown
below.
Example: When reading the frequency displayed in
the center of the display in the VHF band, use code
“0202.”
• Codes for character entries
Command: 1A 00,
1A 05 0144, 0151, 0182, 0259,
0279, 0281, 0293, 0316
1A 05 0262 ~ 1A 05 0265,
1A 05 0268 ~ 1A 05 0271
- Character codes— Letters and Numbers
Character ASCII code Character ASCII code
A ~ Z 41 ~ 5A a ~ z 61 ~ 7A
0 ~ 9 30 ~ 39
- Character codes— Symbols
Character ASCII code Character ASCII code
! 21 # 23
$ 24 % 25
& 26 \ 5C
? 3F ” 22
’ 27 ` 60
^ 5E + 2B
− 2D * 2A
/ 2F . 2E
, 2C : 3A
; 3B = 3D
< 3C > 3E
(
28
)
29
[
5B
]
5D
{
7B
}
7D
|
7C
_
5F
 7E @ 40
Command Set item/selectable characters
1A 00 Memory name
All characters are usable.
1A 05 0144 SET > Network > Network Name
(up to 15 characters)
0151 SET > Network > Network Radio Name
(up to 16 characters)
0182 SET > Time Set > Date/Time >
NTP Server Address
• Memory keyer character entries
Command: 1A 02
- Character codes
Character
ASCII
code
Description
0 ~ 9 30 ~ 39 Numbers
A ~ Z 41 ~ 5A Letters
space 20 Word space
/ 2F Symbol
? 3F Symbol
, 2C Symbol
. 2E Symbol
@ 40 Symbol
^ 5E Example: to send
‒
BT
―
,
enter ^4254
* 2A Inserts contest number
(can be used for 1 channel only)
Remote control
15