Icom IC-A16 Full Manual

SET MODE
15
9
■ Bluetooth settings “
”
(For only the transceiver with built-in Bluetooth unit)
D Bluetooth “ ”
Turn the Bluetooth function ON or OFF.
• OFF: Turns OFF the function.
• ON: Turns ON the function.
D Auto connect “ ”
Select whether or not to automatically connect to the
last bonded Bluetooth device.
• OFF: The user must manually connect to the bonded
device.
• ON: Automatically connects to the last bonded
device.
D Connect/Disconnect
“
” / “ ”
Select this item, and then push [ENT]/[SET] to
connect or disconnect a Bluetooth headset.
D Pairing “ ”
Select this item, and then push [ENT]/[SET] to pair the
Bluetooth headset.
D Headset settings “ ”
SCO “ ”
Select an audio connection option.
• AUTO: Connects only when receiving or transmitting
audio.
Select this option to share a Bluetooth headset
with the transceiver and other devices.
• ALWS: Always connect the audio.
SP Output “ ”
Select whether or not to output audio from the internal
speaker or wired headset when the Bluetooth headset
is connected.
• OFF: Output audio from the Bluetooth headset.
• ON: Output audio from the internal speaker, wired
headset, and the Bluetooth headset.
Icom headset “ ”
Power save “ ”:
Select whether or not to operate in the Bluetooth
headset’s battery saving mode while the optional VS-3
Bluetooth
®
HEADSET is connected.
• OFF: The Power Save mode is OFF.
• ON: The Power Save mode is activated when there
is no communication or operation for 120
seconds.
PTT “ ”:
Set the One-Touch PTT function while the optional
VS-3 Bluetooth
®
HEADSET is connected.
The function enables you to communicate with a
single push of the VS-3’ s [PTT].
• PUSH: Push [PTT] to transmit and release to receive.
• HOLD: Push [PTT] to transmit and push again to
receive.
PTT Beep “ ”:
Set the beep sound when pushing [PTT] on the
optional VS-3 Bluetooth
®
HEADSET.
• OFF: No beep sounds when pushing PTT.
• ON: A beep sounds when pushing PTT.
D Initialize Bluetooth unit “ ”
Initialize the built-in Bluetooth unit.
L “INIT BT?” is displayed for conrmation. Push
[ENT]/[SET] to initialize.
■ CPU version “ ”
Displays your transceiver’s rmware version.
■ Bluetooth unit version “ ”
(For only the transceiver with built-in Bluetooth unit)
Displays your transceiver’s built-in Bluetooth unit
version.
Set mode items (Continued)

Icom IC-A16 Specifications

General

Channel Spacing	8.33 kHz/25 kHz
Number of Memory Channels	200 channels
Antenna Impedance	50 Ω
Waterproof	IP67
Display	LCD
Frequency Range	118.000–136.9916 MHz
Output Power	6 W (PEP), 1.8 W (carrier)
Weight	Approx. 300 g (with standard battery)
Power Supply Requirement	7.2 V DC
Current Drain (Transmit)	1.5 A
Mode	AM
Channels	200
Voltage	7.2V