12
4
MEMORY OPERATION
■ Memory channel selection
The transceiver has 200 memory channels for storage of
often-used frequencies along with 6-character notes.
q Push [MR•
MW] to select memory mode.
• Memory BANK number and memory CH number appears.
Using [DIAL]:
w Push , then push [0•
BANK], and rotate [DIAL] to select
the desired memory BANK number, then push [ENT] (or
[CLR•
DEL]) to exit the BANK selection mode.
e Rotate [DIAL] to select the desired memory CH number.
• If no memory CH is programmed in the selected BANK, no
memory CH selection is available.
Using the Keypad:
w Push , then push [0•
BANK], and push appropriate digit
key ([0•
BANK] to [9•TAG]) to select the desired memory
BANK number, then push [ENT] (or [CLR•
DEL]) to exit the
BANK-selection mode.
e Push [MR•
MW], then push 2 appropriate digit key (00 to
19) to select the desired memory CH number.
• If no memory CH is programmed in the selected BANK, no
memory CH selection is available.
NOTE: Comments appear first when programmed, how-
ever, the transceiver can be programmed by your dealer to
show the operating frequency first. Push [MR•
MW] to dis-
play the comment in this case.
■ Transferring memory
contents
This function transfers a memory channel’s contents into the
frequency mode. This is useful when searching for signals
around a memory channel’s frequency.
q Push [MR•
MW] to select memory mode.
w Select the desired memory channel to be transferred using
[DIAL] or keypad.
e Push , then push [MR•
MW] to transfer the memory
channel’s contents into the frequency mode.
• BANK number and memory CH number disappears as fre-
quency mode is automatically selected and the memory contents
are transferred.
To Next Page
