17
5
SCAN OPERATION
■ “TAG” channel setting
Memory channels can be specified to be skipped for the
memory channel scans respectively. The “TAG” channel func-
tion is only available during scan operation.
q Push [MR•
MW] to select memory mode.
w Select the desired memory channel to be a “TAG” chan-
nel.
• Push , then push [0•BANK], and rotate [DIAL] to select the
BANK number if desired. Push [CLR•DEL] to exit the BANK se-
lection mode.
e Push
,
then push [9•TAG] to set a “TAG.”
•“TAG” appears.
• Non-“TAG” channels are skipped during scan.
r To cancel the “TAG” setting, repeat above steps.
Memory channel 15 is
scanned during memory
scan.
Memory channel 15 is
skipped during scan.
To Next Page
