Icom IC-A6 User Manual

1
1
ACCESSORY ATTACHMENT
Antenna ï
CAUTION: DO NOT transmit without an antenna. Other-
wise the transceiver may be damaged.
Insert the supplied antenna into the antenna connector and
screw down the antenna as shown below.
Belt clip ï
Conveniently attaches to your belt.
Attach the belt clip with the supplied screws as below.
NOTE: Use the supplied screws only.
Battery pack replacement ï
Before replacing the battery pack, push [PWR] for 2 seconds
to turn the power OFF.
Slide the battery release button forward, then pull the battery
pack upward with the transceiver facing away from you.
Supplied screws
NOTE: About water resistant construction
The water resistant construction provides reliable opera-
tion in wet conditions.
• Equivalent to IPX4 of corresponding international stand-
ard IEC 60529 (2001).
2
3
1
4
5
6
7
9
10
8
12
13
11
14

Icom IC-A6 Specifications

General

Frequency Range	118.000–136.975 MHz
Channel Spacing	25 kHz
Antenna Impedance	50Ω
Power Supply Requirement	7.2 V DC
Waterproof	No
Channels	200 channels
Current Drain	1.5 A (at max output)
RF Output Power	5 W (PEP)
Modulation	AM
Battery Life	15 hours
Weight	430g
Dimensions	54 x 129.3 x 35.5 mm